SAES Getters MonoTorr PS4 Phase II 3000 Gas Purifier

PS4-MT3-N-1/R-1 nitrogen purifier, 110V. This MonoTorr purifying alloy is selected to purify nitrogen; others will purify rare gases (H3, Ne, Ar, Kr, Xe). The specifications below are for this nitrogen Phase ll, 3000 series 110 VAC purifier.

Click here to see the serial number back plate.

The purifier has an electropolished interior surface, minimal dead space, and is easy to install. The purifier is completely assembled, with 1/4" male and female ultra-high purity (UHP) face seal fittings for gas inlet and outlet. It includesinlet and outlet stainless steel diaphragm valves, 0.003 micron particle filter, and an on-board electronic control unit. All nitrogen and rare gas purifiers have a Life Status Sensor (LSS) as an impurity breakthrough indicator.

All impurities are chemically bonded to the purifier material. The purifier will not release the trapped impurities under vacuum, high pressure, room temperature or maximum design temperature, even when purifier nears its maximum capacity for impurities.

Read more specifications at SAES Getters Pure Gas Technologies.

Specifications	Rare Gas & Nitrogen
Maximum Flow Rate	MT3: 50 SLPM (1.0 SLPM minimum) MT15: 75 SLPM (1.5 SLPM minimum)
Nominal Flow	MT3: 5 SLPM, MT15: 15 SLPM
Maximum allowable working pressure	10 bar (150 psig)
Operating temperature	Nitrogen: 350°C, Rare Gas: 400°C
Outlet gas temperature	50°C
Installed power	MT3: 300W Optional 120 VAC: MT15: 600W MT3: 330W Optional 220 VAC: MT15: 660W
Getter confinement	15 um in/out porous SS filter
Inlet connection	1/4" face seal female fitting
Outlet connection	1/4" face seal male fitting
Pneumatics connection	1/4" NPT female fitting
Valves	Three, diaphragm type, air actuated
Pneumatics utilities	Nitrogen or clean dry air at 80-100 psig, filtered to 10 um
Filter	.003 um all-metal type
Control unit	Discrete analog temperature controller with alarm and shut-down features